This mounting method described is only one method of installing a weather vane. Mounting a weather vane should not take you much time. The caulk will also help secure the weather vane. Make sure the hole you drilled is entirely sealed off from rain and snow. This area will be exposed to the elements, so you don’t want any leakage. Load your caulking gun with the waterproof caulk and apply a solid bead around the brass rod where it comes out of the roof. Double check the set screws on the weather vane are all tight, the directional points north and the ornamental spins freely. Make sure the brass rod is inserted as far as it can go into the ridgepole. The weather vane should not wobble, and it should stand perfectly straight. Once the right size hole has been drilled, insert the weather vane into it. You should insert about eight to nine inches of the 28-inch rod into the ridgepole. If you are uncertain about the fit, make a test drill into a spare piece of wood to see how the rod will fit. Make sure the drill bit is no larger than the brass rod. On the roof, with your power drill, drill a vertical hole directly into the ridge point of the roof. This is the beam into which you will need to drill to mount the brass rod. Post Barns Metal Wind Vane Sheds Gardens (Angler) Halloween Weather Vanes for Roofs Weathervanes Roof Mount Cupola Yard Weathervanes for Garden Animal. Go into your attic and find the ridgepole-the horizontal beam that runs the length of the roof’s ridge. Step 2 - Drill into Head Block or Ridgepole Use your screwdriver to tighten the set screws and assemble the entire weather vane. The directional should not spin but point towards the north. The ornament is affixed to the stainless steel rod, which sits inside of the brass rod, and is able to spin. Mounting screws are not included in the purchase of this mount.A traditional weathervane will have a brass rod approximately 28 inches long, a large and a small copper globe, a brass collar with set screws, a directional with set screws, a spinning ornament and a stainless steel inner rod and ball bearing. Roof Mount is adjustable, but is made to a 4/12 roof pitch.Mounting screws are not included in the purchase of this mount. 4 Sided Mount is made for mounting to a 4 or 8 sided cupola or gazebo.Post Mount or (side mount) will mount to the side of a fence of vertical board.Insert the ground stake into the ground and slide the garden mount right over the top of it.

The garden mount must be screwed together upon arrival. Garden Mount – A 2-piece 60″ garden mount includes stabilizing ground stake.Deck Mount will mount to a flat board i.e.

But if you need to purchase an extra Weathervane Mount, buy it here! The Weathervanes come with your choice of deck mount, roof mount, post mount, garden mount, or 4 sided mount. Order your weathervane online now or contact our Help Desk at 20 for Questions or to Order over the Phone. Each Weathervane is handmade to order for our great customers. Step 3: Drill the pilot holes for your mount. Copper Weathervanes - Made in USA - All are Cupola Ready. Step 2: Use a level to ensure the rod is straight and use a pencil to mark the screw holes. with a weathervane shaped like a dove representing peace.5 The roof was rust. Step 1: Place the roof mount on your roof and add the assembly rod that came with your weathervane. Description Extra Weather Vane Mount for EZ Vane Weather Vanes Martha Washington passed away in May 1802.1 Her death capped.

Mounting weathervane on roof